BenchDELUXE – Help & Support

Here you will find information on how to setup & maintain your BenchDELUXE labeling machine.

Setting up the BenchDELUXE

This video takes you through the entire setup for the BenchDELUXE labeler.

Removing and cutting the blue rollers

If you need to change over or make a smaller roller. Watch this video to see how to remove the blue rollers and how to cut them to fit your container if needed.

My Labels are slipping or tracking on my machine

If you find your labels are slipping or tracking on the BenchDELUXE, watch this video to find ways to troubleshoot and resolve this issue.

For more information on bottles, please watch the below videos for the correct material:

Changing over the handle roller

Watch this video to see how to change the handle roller over.

Turning on the long label switch

Do you have a label that is longer than 230mm? This video will show you how to turn on the long label switch to allow for longer labels.

Attaching the Small Bottle Adaptor

This video shows how to attch the SBA, if purchased for the BenchDELUXE.

Removing the Small Bottle Adaptor

This video demonstrates the steps on removing the SBA from the machine, if you have purchased one for the BenchDELUXE.

My machine is not applying labels

This video demonstrates the steps to troubleshoot if no labels are being applied to your container.

My Machine is spitting out or applying multiple labels

This video demonstrates the steps on how to troubleshoot the machine if it is spitting out multiple labels.

Tips to prevent this issue from happening in the future:

Don’t pick up machine with the sensor rod
Don’t put excessive weight on the sensor rod
Keep the sensor clean
Make sure the wheel is turning freely